Written by
Miles Hartwell Editorial authorPublished September 11, 2026
Content status:
Verified
Error codei10
ApplianceDishwasher
Affected model seriesEI24ID50Q family
Quick answer
i10 — Electrolux dishwasher code i10 indicates low water fill detected.
Model compatibility: Electrolux reuses codes across series and model years, so i10 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
If your Electrolux dishwasher displays i10, the control has detected low water fill detected. Start with the checks that are safe to perform without opening the appliance. Use the observed symptoms and the full model number to confirm the correct diagnostic path.
Signs
Symptoms you may notice
dishwasher may pause during fill
little water may enter the tub
cycle may not advance normally
Why it happens
Possible causes
water supply valve not fully open
pinched or restricted inlet line
low incoming water flow
inlet valve or control issue
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Confirm the water shutoff valve is fully open.
Inspect the accessible inlet line for kinks or crushing.
Cancel the cycle and try one restart after restoring normal water flow.
Do not remove panels to test the inlet valve or wiring.
Important safety warning. Stop if there is active leaking or repeated fill attempts without normal water entry.
Get help
When to call a technician
Schedule repair if i10 returns after the water supply and inlet line are confirmed normal.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux dishwasher repair in Los Angeles for drain, fill, circulation, drying, leak, latch, and electronic-control problems. Confirm coverage by ZIP.
It indicates low water fill detected. Confirm the full model number because Electrolux diagnostic meanings can vary between control platforms.
You can try the safe external checks on this page and one power reset when appropriate. If the code returns, repeated resets are not a substitute for diagnosis.
Do not continue repeated cycles if the dishwasher cannot fill normally. Correct an external water-supply issue once, then test one cycle.
References
Sources & references
Electrolux EI24ID50Q use-and-care/error guide.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
