Written by
Miles Hartwell Editorial authorPublished September 11, 2026
Content status:
Verified
Error codeE13
ApplianceWasher
Affected model seriesEFLS617SIW / EFLS517SIW / EFLW417SIW
Quick answer
E13 — Electrolux washer code E13 indicates water leak in the tub or pressure-sensing system.
Model compatibility: Electrolux reuses codes across series and model years, so E13 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
An Electrolux washer displaying E13 is reporting water leak in the tub or pressure-sensing system. Start with the simple checks that are safe to do from outside the appliance, then stop if the code returns. Do not replace parts from the code alone; use the full model number and the observed symptoms to confirm the cause.
Signs
Symptoms you may notice
washer may stop during fill or wash
water level behavior may be abnormal
water may be visible where it should not be
Why it happens
Possible causes
an actual internal or hose leak
a pressure-sensing problem
an air-tube issue
a control-board problem
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Stop the cycle if you can see water escaping from the washer.
Check the fill and drain hoses from the outside for loose connections or visible damage.
Make sure the drain hose is positioned correctly and is not siphoning.
Do not remove panels to inspect the pressure system or internal tub.
Important safety warning. Stop if you see active leaking, water under the machine, or repeated filling/draining behavior.
Get help
When to call a technician
If E13 returns after the safe checks, schedule repair. A technician can follow the model-specific diagnostic path and test the components associated with water leak in the tub or pressure-sensing system.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux washer repair in Los Angeles for fill, drain, spin, door-lock, vibration, motor-control, heater, and E-series faults. Confirm coverage by ZIP.
It indicates water leak in the tub or pressure-sensing system. Confirm the full washer model because diagnostic meanings can vary between control platforms.
You can try the safe external checks listed above and one power reset where appropriate. If the code returns, repeated resets are not a substitute for diagnosis.
Avoid continued use if there is leaking, overheating, an electrical symptom, a locked door, or abnormal drum movement. Otherwise, correct any simple installation or load issue and test once.
References
Sources & references
Electrolux EFLS617SIW / EFLS517SIW / EFLW417SIW Technical & Service Manual, Error Code Table and model-specific troubleshooting.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
