Model compatibility: Electrolux reuses codes across series and model years, so E31 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
An Electrolux washer displaying E31 is reporting electronic pressure sensor error. Start with the simple checks that are safe to do from outside the appliance, then stop if the code returns. Do not replace parts from the code alone; use the full model number and the observed symptoms to confirm the cause.
Signs
Symptoms you may notice
incorrect water-level behavior
cycle may stop unexpectedly
fill or drain behavior may seem abnormal
Why it happens
Possible causes
pressure sensor problem
air-tube or air-trap restriction
incorrect pressure calibration
main control-board issue
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Turn the washer off and disconnect power for several minutes.
Check that the drain hose installation is correct and that the washer is not siphoning.
Look for obvious overfilling or water remaining in the drum.
Do not open the cabinet or disconnect the pressure hose unless you are trained to service appliances.
Important safety warning. Stop user-level troubleshooting if the code returns after one safe reset/check cycle or if the washer shows leaking, overheating, electrical, or mechanical symptoms.
Get help
When to call a technician
If E31 returns after the safe checks, schedule repair. A technician can follow the model-specific diagnostic path and test the components associated with electronic pressure sensor error.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux washer repair in Los Angeles for fill, drain, spin, door-lock, vibration, motor-control, heater, and E-series faults. Confirm coverage by ZIP.
It indicates electronic pressure sensor error. Confirm the full washer model because diagnostic meanings can vary between control platforms.
You can try the safe external checks listed above and one power reset where appropriate. If the code returns, repeated resets are not a substitute for diagnosis.
Avoid continued use if there is leaking, overheating, an electrical symptom, a locked door, or abnormal drum movement. Otherwise, correct any simple installation or load issue and test once.
References
Sources & references
Electrolux EFLS617SIW / EFLS517SIW / EFLW417SIW Technical & Service Manual, Error Code Table and model-specific troubleshooting.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
