Written by
Miles Hartwell Editorial authorPublished September 11, 2026
Content status:
Verified
Error codeE45
ApplianceWasher
Affected model seriesEFLS617SIW / EFLS517SIW / EFLW417SIW
Quick answer
E45 — Electrolux washer code E45 indicates line door sensing failure.
Model compatibility: Electrolux reuses codes across series and model years, so E45 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
An Electrolux washer displaying E45 is reporting line door sensing failure. Start with the simple checks that are safe to do from outside the appliance, then stop if the code returns. Do not replace parts from the code alone; use the full model number and the observed symptoms to confirm the cause.
Signs
Symptoms you may notice
door may not lock or unlock normally
washer may not start
cycle may stop with the door-related code
Why it happens
Possible causes
door-lock device problem
lock wiring issue
door-sensing circuit problem
main control-board issue
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Check that the door is fully closed and nothing is trapped in the opening.
Inspect only the visible latch area for debris or physical damage.
Power the washer off for several minutes and retry once.
If the code returns, avoid repeated start attempts because the lock/control circuit needs testing.
Important safety warning. Stop user-level troubleshooting if the code returns after one safe reset/check cycle or if the washer shows leaking, overheating, electrical, or mechanical symptoms.
Get help
When to call a technician
Book service if E45 returns after a power reset. This code can involve internal wiring, controls, sensors, relays, pumps, or motor electronics that should be tested with the appliance made electrically safe.
Seeing this code on your Electrolux appliance?
Book a specialist visit for a clear estimate and approval before any repair.
Electrolux washer repair in Los Angeles for fill, drain, spin, door-lock, vibration, motor-control, heater, and E-series faults. Confirm coverage by ZIP.
It indicates line door sensing failure. Confirm the full washer model because diagnostic meanings can vary between control platforms.
You can try the safe external checks listed above and one power reset where appropriate. If the code returns, repeated resets are not a substitute for diagnosis.
Avoid continued use if there is leaking, overheating, an electrical symptom, a locked door, or abnormal drum movement. Otherwise, correct any simple installation or load issue and test once.
References
Sources & references
Electrolux EFLS617SIW / EFLS517SIW / EFLW417SIW Technical & Service Manual, Error Code Table and model-specific troubleshooting.
Ready to get your Electrolux appliance working again?
Book a repair online or call us — clear estimates and approval before any repair work begins.
